Furnace Ultimate Tune Up

This multi-point inspection and service will ensure peak operating performance and maximum energy efficiency.

- Test operation
- Replace or clean filter
- Test for gas leaks
- Inspect safety controls
- Test for proper drafting of vent and inspect vent condition
- Check heat exchanger for cracks, rust and soot
- Record carbon monoxide levels in the air stream and vent system
- Clean burners/pilot assembly
- Ensure blower is clean
- Clean furnace cabinet inside & out
- Lubricate, adjust and tighten blower assembly to factory specifications
- Check electrical connections for tightness
- Adjust and calibrate thermostat
- Record amp draw on blower motor
- Record entering and leaving air temperatures
- Check manifold pressure
- Inspect condition of water heater